Problem 22-7 Source:
Exercise 7.8 - page 266
Book: Circuit Analysis in Engineering - J. David Irwin - 4ª edition - Ed. Pearson.
In the circuit shown in Figure 22-07.1, the switch S remained open for a long period.
At t = 0 the switch is closed.
Determine the response of Vo (t).
Figure 22-07.1
Solution of the Problem 22-7
With the switch S open for an extended period, we know that the capacitor acts as an open circuit.
Therefore, there will be no current flowing through it or the two voltage sources. So, all the current from the
3 A source will flow through the two 4 Ω resistors. Calculating the value of
Vx is very easy, just apply Ohm's law, or:
Vx = 4 x 3 = 12 volts
To determine the value of Vo (0-), we simply need to create the loop
composed of the two voltage sources and the 4 Ω resistor. Therefore:
Vo(0-) = Vx + 24 + 2 Vx = 60 volts
From this point on, we will consider the switch S
closed and therefore the current source of 3 A is out of the circuit.
Since the capacitor cannot drastically change its voltage, we conclude that:
Vo(0+) = Vo(0-) = 60 volts
On the other hand, when t → ∞, the capacitor is an open circuit
and there will be no current flowing through the circuit. Therefore, Vx = 0. It is clear
that the voltage of the 24 volts source will be in parallel with the capacitor. So:
Vo(∞) = 24 volts
All that remains is to calculate the circuit's time constant. To do this, we will remove the capacitor
from the circuit and determine the Thévenin equivalent of the rest of the circuit. We will short-circuit
the independent 24 volts source and observe that, with the closing of the switch S, the two 4 Ω
resistors are in parallel.
Therefore, we will replace them with a single 2 Ω resistor. Thus, we are left with the circuit shown in Figure 22-07.2.
In this circuit, we introduced a current source I in place of the capacitor. To find Rth, we must
calculate the ratio V / I.
Figure 22-07.2
Note that the current circulating through the circuit is I. Therefore, Vx = 2 I. Thus,
by constructing the loop we find:
V = 3 Vx = 6 I
Thus, we find Rth, or:
Rth = V / I = 6 Ω
With the value of Rth, we can calculate the value of the time constant of the circuit.
τ = Rth C = 12 s
Using eq. 22-03, we can write the solution equation for the circuit in the problem.