Problem 16-7 Source:
Problem created by the site's author.
Calculate the values of R1, R2 and R3
so that the voltmeter represented in Figure 16-07.1 can measure up to 1 volt when
the selector switch is in position x1, 10 volts in position x10 and
100 volts in position x100. The measuring instrument is a microammeter
with a full scale of 100 µA and internal resistance of 500 Ω.
Figure 16-07.1
Solution of the Problem 16-7
Initially, we will calculate the voltage necessary for the instrument to have maximum deflection.
We know that the full scale is 100 µA and the internal resistance is 500 Ω.
So, the voltage is:
Vg = Ri Ig = 500 x 0,0001 = 0.05 V
Solution for position x1
Therefore, to be able to measure 1 volt, we need an external resistor that
should provide a voltage drop of: Vr = 1 - 0.05 = 0.95 volt.
So, let's calculate the value of R1 when the selector switch
is positioned at x1. Like this:
R1 = (V - Vg) / Ig = (1 - 0.05) / 0.0001 = 9500 Ω
Another way to calculate the value of R1 would be to calculate the
total resistance that the circuit should have and, subsequently, subtract the
value of Ri. Look:
Rtotal = V / Ig =1 / 0.0001 = 10,000 Ω
Now we subtract the value of Ri from Rtotal, obtaining:
R1 = Rtotal - Ri = 10,000 - 500 = 9,500 Ω
Solution for position x10
Looking closely at the circuit, we realize that when
the selector switch is in position x10, the resistor R1
will be in series with R2 as well as Ri. So, we can
calculate the value of R2 by calculating the total resistance and
then subtract the values of Ri and R1. Therefore:
Rtotal = V / Ig = 10 / 0.0001 = 100,000 Ω
Subtracting from Rtotal the value of Ri + R1,
you get:
Following the same previous reasoning and realizing that when
the selector switch is in position x100, the resistor R1,
R2, as well as Ri, will be in series with
R3. Therefore, one can
calculate the value of R3 by calculating the total resistance and
then subtract the values of Ri, R1 and R2.
Therefore:
Rtotal = V / Ig = 100 / 0.0001 = 1,000,000 Ω
Subtracting from Rtotal the value of Ri +
R1 + R2, we obtain:
R3 = Rtotal - Ri - R1 - R2
Replacing the variables with their respective numerical values, we find for R3 the value of:
R3 = 900,000 Ω
Note that in this type of circuit we will always have the sum of the previous resistors
for each scale we choose. This is normally the circuit used in instruments
professionals.
Finally, we can calculate the sensitivity of the instrument: