Problem 13-17
Source:
Problem developed by the site's authors.
a) Find the values of I1, I2 and I3.
b) Find the values of the currents flowing through the voltage sources and the power supplied or received by them.
Figure 13-17.1
Solution of the Problem 13-17 -
Kirchhoff's Method
Item a
The circuit in Figure 13-17.1 shows that between points c and d, there are four resistors connected to each other,
with two resistors in parallel.
The parallel of 36 Ω and 18 Ω results in an equivalent resistor of 12 Ω. Thus,
adding the values of the resistors, we find an equivalent resistor between points c and d of 40 Ω.
Applying Ohm's law, the value of I1 is easily found, or:
I1 = 80 / 40 = 2 A
For the loop I2:
18 I2 - 10 I3 = 80
And finally, for I3, we have:
- 10 I2 + 22 I3 = 9
Therefore, we have a system of two equations with two unknowns that can be solved by any method. We find the following values:
I1 = 2.0 A
I2 = 6.25 A
I3 = 3.25 A
Item b
To find the current flowing through the 80 V voltage source, we must solve the
equation of the nodes for node d, since it is easy to verify that the current flowing
through the voltage source is the sum I1 + I2, that is:
I80 = I1 + I2 = 2 + 6.25 = 8.25 A
For the 9 V source, the current flowing through it is the current I3 itself.
Note that in the case of the two voltage sources, the currents are flowing out of the positive terminal.
Therefore, both sources supply power to the circuit. So:
P80 = - 80 x 8.25 = - 660 W
And for the 9 V source, we have:
P9 = - 9 x 3.25 = - 29.25 W
Therefore, the total power supplied to the circuit is the sum of the powers calculated above, that is,
- 689.25 W. On the other hand, it is known that this power must be equal, in modulus, to the
power dissipated by all the resistors that make up the circuit.
It is left as an exercise for the reader to prove this statement.